Balance of System

Safety Disconnect
Electrical code requires that your system has a means of disconnecting power during servicing. The disconnect will cut the charging circuit as required. Two-pole circuit breakers are extra.
# 03-17-001 Safety Disconnect Enclosure - 2 Breaker
# 03-17-002 Safety Disconnect Enclosure - 4 Breaker

DC Fuse Enclosure
Wall-mountable, enameled steel construction. CSA approved, DC rated breakers snap into the load centres. Breakers are available in sizes from 15 - 60 A.


# 03-17-003 Load Center - 8 Breaker
# 03-17-004 Load Center - 12 Breaker
# 03-17-006 15 AMP DC Double Pole Breaker
# 03-17-007 20 AMP DC Breaker
# 03-17-008 20 AMP DC Double Pole Breaker
# 03-17-009 30 AMP DC Breaker
# 03-17-010 30 AMP DC Double Pole Breaker
# 03-17-011 40 AMP DC Breaker
# 03-17-012 40 AMP DC Double Pole Breaker
# 03-17-013 60 AMP DC Breaker
# 03-17-014 60 AMP DC Double Pole Breaker

Power Centre
A simple and safe way to wire six 30 A circuits. Uses standard auto fuses and has a hinged plastic cover.
# 03-45-001


Combiner Boxes
Our code-approved Combiner Boxes provide a convenient, low cost method for the fusing of photovoltaic modules accommodating up to 12 DIN rail breakers for 150 VDC (max) systems, or up to 8 "touch safe" type fuse holders for 600 VDC (max) systems.
# 03-77-001 holds up to 3 DIN breakers
# 03-77-002 holds up to 6 x 150 VDC, or 4 x 600 VDC
# 03-77-003 holds up to 12 x 150 VDC, or 10 x 600 VDC
# 08-53-122 holds up to 8 DIN breakers or up to 6 fuseholders
# 08-53-168 holds up to 12 DIN breakers or up to 8 fuse holders

# 08-53-090 Fuse 10 A, 600 VDC max # 08-53-091 Fuse 15 A, 600 VDC max # 08-53-092 Fuse 6 A, 600 VDC max # 08-53-093 Fuse holder 30 A, 600 VDC max # 08-53-094 DIN PV breaker 10 A, 150 VDC max # 08-53-095 DIN PV breaker 15 A, 150 VDC max # 08-53-097 DIN PV breaker 30 A, 150 VDC max

# 08-53-094

Low Voltage Disconnects
Xantrex low voltage disconnect. Flush mount with terminal connections, 35, 40 and 60 A capacity.
# 04-16-004 35 A 12/ 24 V
# 04-16-005 40 A 12/ 24/ 48 V
# 04-16-007 60 A 12/ 24/ 48 V

The TriMetric is used to monitor 12-48 VDC battery systems used in remote homes, RV's or boats that have batteries that store solar, wind, or generator powered chargers. TriMetric's TM-2025 designed to monitor the following:
. "Percent Full" ("State of charge") of your batteries, so you can see if you need to charge them more, or check that overall usage is more than your charging resources.
. Volts of the batteries, for example to check that they are beingless charged at proper voltage.
. Energy going in, or out of your batteries, measured in Amps or Watts, so you can see that your charging sources are charging properly, or how much current your loads are using.
. How many days since the batteries were fully charged: to remind you to not wait too long between fully charging your batteries to maximize their life.
. The TM2025 A is designed to fit an a "double gang" electrical box of appropriate size (not supplied). It has a serial data output of all the "real time" data-which could be used to access data for other control or output in, for example OEM applications.
# 03-22-001

Watt-Meter This very affordable watt-meter tracks the instantaneous or cumulative energy consumption of any 120 VAC appliance rated up to 15 A. With the large LCD display you may monitor voltage, amperes, watts, line frequency, and power factor with up to 0.2 % accuracy.
# 03-59-001

Mercury Relays
We offer very reliable mercury contactors of 35, 60 and 100 A rating. Specify voltage and normally open (NO) or normally closed (NC) operation at time of order.
# 02-01-001 35 A
# 02-01-002 60 A
# 02-01-003 100 A

Voltage Controlled Switch
Used for adjustable voltage on / off control of devices. Examples are backup generator control, fluid level control, simple charge controller, simple LVD relay control, battery vent controller etc. 12 - 48 VDC
# 04-25-010 High Active
# 04-25-011 Low Active

Single DC Current Shunts
Allows measurement of large DC currents with standard volt meters. Brass with insulated base.
# 03-49-009 100 A 100 mV
# 03-49-010 500 A 50 mV

Blocking Diodes
Protects batteries from reverse current leakage at night through the solar array.
# 16-49-011 Fused Diode Assembly, 3 A
# 16-49-012 Fused Diode Assembly, 6 A

Lightning Arrestors
These lightning arrestors safeguard 12 VDC PV systems against lightning damage. Rated for 50,000 volts.
# 03-30-001 Lightning and surge arrestor Heavy duty lightning and surge arrestor for AC or DC circuits and applications, such as photovoltaic systems.
# 03-11-001 Lighting arrestor-AC
# 03-11-002 Lighting arrestor-DC
# 03-11-005 3-Phase 600 VAC Lightning Arrestor, 3 Wire

Tigo Energy Maximizers

Tigo maximizers deliver the best solution, at the lowest cost for optimized on-grid or off-grid system performance combining the benefits of granular measurement and control and system reliability at the lowest cost and greatest level of security. When coupled with your choice of central inverter, Tigo Maximizers deliver all the features promised by micro-inverter technologies without the cost, conversion efficiency, heat and reliability penalties associated with these small inverters. .

Part Number	Description	Model Number
08-91-001	TIGO ES MAXIMIZER, 50 V, 300 W - 3 W, MC3	ES050V300W-3W
08-91-002	TIGO ES MAXIMIZER, 50 V, 300 W - 4 W, MC4	ES050V300W-4W
08-91-003	TIGO ES MAXIMIZER, 50 V, 300 W - 5 W, TYCO	ES050V300W-5W
08-91-004	TIGO ES MAXIMIZER, 50 V, 300 W - 6 W, H-S	ES050V300W-6W
08-91-005	TIGO ES MAXIMIZER, 75 V, 350 W - 4 W, MC4	ES075V350W-4W
08-91-006	TIGO ES MAXIMIZER, 75 V, 350 W - 5 W, TYCO	ES075V350W-5W
08-91-007	TIGO ES MAXIMIZER, 110 V, 300 W - 3 W, MC3	ES110V300W-3W
08-91-008	TIGO ES MAXIMIZER, 110 V, 300 W - 4 W, MC4	ES110V300W-4W
08-91-009	TIGO ES MAXIMIZER, 170 V, 300 W - 4 W, MC4	ES170V300W-4W
08-91-010	TIGO MGMT UNIT, SERIES CONFIG	MU-ESW
08-91-011	TIGO MGMT UNIT, PARALLEL CONFIG	MU-EPW
08-91-012	EXTRA GATEWAY	MU-GTWY
08-91-013	TEMPERATURE SENSOR, Y CABLE	TS
08-91-014	LIGHT SENSOR, Y CABLE	LS
08-91-015	REVENUE GRADE AC METER	REVAC
08-91-016	TIGO MONITORING, 5 YR UP TO 10 KW	MP-RES 5 YEAR
08-91-017	TIGO MONITORING, 5 YR OVER 10 KW	MP-COM 5 YEAR
08-91-018	TIGO MONITORING, 10 YR UP TO 10 KW	MP-RES 1- YEAR
08-91-019	TIGO MONITORING, 10 YR OVER 10 KW	MP-COM 10 YEAR
08-91-020	TIGO MONITORING, 20 YR UP TO 10 KW	MP-RES 20 YEAR
08-91-021	TIGO MONITORING, 20 YR OVER 10 KW	MP-COM 20 YEAR

 

 

The information contained herein is subject to change without notice.